Description

ARP Vevstaksbultar BMW S85B50 V10 (CA625+)

Material: CA625+

Part Number: 201-6002

Application: BMW 5.0L (S85) V10

Cap Screw without Washer – Rod Bolt Installation

[1] Please check the part-number(s) for your application

against the part-number(s) listed on the instruction sheet.

[2] Make sure there is an adequate chamfer around the bolt

hole on the connecting rod cap to clear the radius under

the head of the bolt.

[3] Lubricate the threads and the under head of the bolt with

ARP Ultra-Torque Fastener Assembly Lubricant.

[4] ARP recommends using the STRETCH METHOD when

tightening rod bolts. Following the instructions for using a

stretch gauge, Stretch the bolts to

. 0075” – .0080”

[5] If you do not have a stretch gauge, torque the bolts to:

60 ft-lbs

[6] The connecting rods should always be re-sized after new

rod bolts are installed.

[7] A log should be kept on the original non-torqued length

of each bolt. Bolts that have any permanent deformation

or have increased in non-torqued length by more than

.001 in. should be replaced.

Specifikation

Bilmärke	BMW
Motorkod	S85